In Store Pick-Up in Bend, Oregon
We installed a 2" receiver hitch onto a 2021 Audi Q3. The hitch was manufactored by Stealth Hitches. The hitch was manufactured by Stealth Hitches and has a tongue weight capacity rating of 600lbs and a gross trailer weight capacity rating of 6,000lbs. The installation was difficult and required us to remove the bumper fascia and should be done by trained specialists only.
We installed crossbars onto a 2019 BMW X4. The crossbar setup was manufactored by Thule and has weight capacity rating of 165lbs. These crossbars are equipped with a channel within the bars to allow mounting for certain accesories. They are attached to the vehicle using Thule Flush Rail feet and Kit 186007. Installation difficulty was moderate.
We installed a 2" receiver hitch and wiring onto a 2020 Ford Ranger. The hitch was manufactored by Drawtite and has a tongue weight capactiy rating of 1,125lbs and a gross trailer weight capacity rating of 7,500lbs. The installation of the hitch and wiring was difficult and should be done by trained specalists only.
We installed a 1.25" receiver hitch onto a 2021 Kia Stinger. The hitch was manufactured by Drawtite and has a tongue weight capacity rating of 200lbs and a gross trailer weight capacity rating of 2,000lbs. The installation was difficult and should be done by trained specalists.
We installed crossbars and kayak racks onto a 2021 Audi Q3. The crossbars and kayak racks were manufactored Thule. On this setup, the kayak rack known as the Thule Hullavator is mounted into the channel of the crossbars. The Hullavator is equipped with a gas strut to help ease the process of loading and unloading the kayak as it comes down to the side of the vehicle. The load capacity of the Hullavator is 75lbs per boat.
We installed track and crossbars onto the canopy of a 2016 Ram 1500. The roof rack system we found that works best for fiberglass canopies is made by Rhino Rack. This installation required us drill through the canopy and install the track using bolts, nuts and silicone sealant. Once attached, the feet that we used are Rhino Racks RLT 600's paired with VA 165B crossbars which have channel mount capability. The weight capacity for this setup is rated for 165lbs.
We installed a truck bed rack onto a 2021 Toyota Tacoma. This truck bed rack is manufatured by Thule and is known as the TracOne. The TracOne can support up to 800lbs, and is eqquiped with track ontop of the bars to allow the loadstops to slide to the desired length. A Thule TracOne Tacoma Accessory Track Kit is needed to attached the bed rack to the vehicles existing bed rails.